Table of Contents
Advertisement
Output Settings
Here you can change various settings that influence the output from the module.
Items you can change:
Duplicate
Min Interval
Gross Text
Net Text
Print On Error
Mantracourt Electronics Limited
Whether to produce the same output twice each time an output is triggered.
Useful, for example, with a printed output where a customer requires a receipt.
Minimum time allowed between triggered outputs entered in milliseconds.
Triggers arriving within this time since the previous trigger will be ignored.
Example: A Data Tag is used to supply data to input 1 and is used to trigger an
output. This data arrives at a rate of 50 per second but the output is connected
to a serial display which would have problems if it were sent data at this rate. By
setting the Min Interval to 300 the outputs would be limited to 3 per second
even though the data was arriving at a higher rate.
Enter text to replace the <GN> token with when the module is in gross mode.
Enter text to replace the <GN> token with when the module is in net mode.
Whether to trigger an output when any input module fails to deliver new data
within the timeout period.
Example: Data arrives which is used as input 1. This same data tag is used to
trigger an output which is sent to a serial display. Normally if the data fails to
arrive the display would not get updated as no output would occur. By setting
this property an output would be triggered when the data failed to arrive thus
setting the serial display which would show ------- instead of the value when
<V1> is decoded.
249
T24 Telemetry User Manual
Advertisement
Table of Contents
