Table of Contents
Advertisement
Value/Limit
From To
Mantracourt Electronics Limited
5-Remote Error
6-Sum Greater Than
7-Sum Less Than
8-Change Increasing
9-Change Decreasing
10-At Interval
11-Lid Open
12-Local Low Battery
13-External Low Battery
14-High Temperature
15-Low Temperature
16-Digital Input
17-Any global error
Enter the value or limit against which the trigger is tested.
Some triggers are applied to particular input channels and can be applied to
either a single channel or a range of channels. To apply the trigger to a single
channel just enter the same channel in both the To and From fields.
To cover a range enter the required To and From channels.
Channels can either be entered by channel number or hexadecimal Data Tag.
When entering a Data Tag ensure that you use 4 characters i.e. 0F45
Unless Data Tags are manually changed on transmitter
modules the random nature would tend to make entering a
range of Data Tags useless.
Check the specified channels and trigger the
report if any report an error or communications
is lost. This will include battery low errors and
may indicate other internal errors. Refer to the
transmitter module manual section for details.
Check the sum of values from the specified
channel range and trigger the report if the
summed value exceeds the specified value
Check the sum of values from the specified
channel range and trigger the report if the
summed value exceeds the specified value
Not yet implemented
Not yet implemented
Simply send the report at the specified Min
Interval. NOTE that low power modes may stop
the reports from occurring at this rate
Trigger the report if the lid is opened
Trigger the report if the local battery drops
below the specified voltage. The standard
battery is lithium so a value of 3 is
recommended here
Trigger the report if the external supply voltage
drops below the specified voltage
Trigger the report if the temperature measured
on board rises above the specified temperature
Trigger the report if the temperature measured
on board falls below the specified temperature
Trigger the report on detection of the digital
input
Trigger the report if any of the following errors
are detected:
Sim Error, GPRS Network Error, Network Signal
Level Low, T24 Timeout (No data from any
module), Lid open, Realtime Clock Error,
Watchdog and Interrupt errors.
318
T24 Telemetry User Manual
Advertisement
Table of Contents
