Table of Contents
Advertisement
Log Number
Log Digits
Line Delay Char
Line Delay
Mantracourt Electronics Limited
Enter a log number that is used when the <LOG> token is decoded. Each time
an output is triggered this log number is incremented. This number will wrap to
zero once it reaches the maximum value displayable due to the Log Digits.
This parameter is Non Volatile and is stored in internal flash memory each time
the <LOG> token is evaluated in a printout. This takes time and reduces the
finite life of the flash memory so it is recommended that printouts containing
the <LOG> token are not triggered at a rate faster than every 30 seconds.
Set the number of digits to display when the <LOG> token is decoded.
Example: If this is set to 2 then the log number will count up to 99 before
resetting.
This is not alterable and is the character used by the thermal printer to denote
the end of a line. You will see the token <0A> in the Output Design page when
you press the enter key at the end of a line.
This is not alterable but shows the delay in milliseconds required at the end of
each printed line.
277
T24 Telemetry User Manual
Advertisement
Table of Contents
