T24-Antc; Mounting; Specification - Mantracourt T24 User Manual

T24-ANTC

This weatherised omnidirectional antenna provides an antenna solution with an articulated base and is fitted with
a reverse polarity SMA connector.
Intended to be fitted outside an enclosure where it will be attached to a bulkhead or chassis mounted RPSMA
jack which is at one end of a pig-tail with a U.FL connector at the inner end for attachment to a radio module.
Alternatively, the RPSMA bulk-head jack could be at the end of a feeder extension used to facilitate mounting the
antenna some distance from the product enclosure. Feeder extension length depends on the specific application
but in general should not be more than two metres.

Mounting

RPSMA bulk-head or chassis mounting jacks usually require a 6.4 mm diameter hole in the product enclosure or
antenna mounting bracket. These antennae should be mounted so that the element is vertical and ideally at least
one metre from large metal objects or structures.
The user must ensure that the bulkhead mounted connector is sealed to the required level.

Specification

Gain: 2.2 dBi
Type: ½ wave dipole
Connection: Reverse polarity SMA connector on antenna to connect to reverse polarity SMA bulkhead on 100
mm tail to UFL connector.
Environmental Protection: IP67
Mantracourt Electronics Limited
430
T24 Telemetry User Manual