Table of Contents
Advertisement
Advanced Settings
You should not normally need to change these settings.
Items you can change:
Waker Duration
Do Sleep Wake
Auto Off Delay
Keep Awake Interval
Pair Wait Duration
Paired Data Tag
Paired ID
Mantracourt Electronics Limited
When the handheld is turned on it will attempt to wake the paired transmitter
module if Do Sleep Wake is activated. This setting allows you to adjust the time it
will wait to wake the remote module in milliseconds. The default is 12000.
You can select whether the handheld wakes the remote transmitter module on
power up and sends it to sleep on power down.
Select No to disable this function. The default is Yes.
Here you can specify the delay in minutes after which the handheld will
automatically turn off after no button is pressed.
Enter zero to disable this function. The default is 5 minutes.
While the handheld is receiving messages from the transmitter module it
periodically sends out a Keep Awake message. This will stop the transmitter
module from going to sleep while the handheld is in use. The default is 5 seconds.
Here you can set the duration that the handheld will wait to achieve successful
pairing when it is turned on in Pairing mode. The default is 5 seconds.
Indicates the Data Tag of the currently paired transmitter. Enter the Data Tag of the
desired transmitter. Note that the transmitter must be set to the same radio
channel and group key as the hand held module.
Indicates the ID of the currently paired transmitter. Enter the ID of the desired
transmitter. Note that the transmitter must be set to the same radio channel and
group key as the hand held module.
187
T24 Telemetry User Manual
Advertisement
Table of Contents
