Calibration - Mantracourt T24 User Manual

Calibration

This module does not provide calibration, as such, because it is factory calibrated. However, on this page you can
select the units and set an offset if required.
The bottom of the page shows the Input resistance and the Temperature Output.
Items you can change:
Select Units
Offset
Mantracourt Electronics Limited
Simply select the required temperature units from the drop down list.
If you change units you will have to adjust any entered offsets below.
This allows you to compensate for resistances in the sensor cable or to just
generally apply an offset to the output.
The value you enter here will be subtracted from the measured temperature to
create the transmitted temperature. The offset is entered in the same
engineering units as selected above.
113
T24 Telemetry User Manual