Commands - Mantracourt T24 User Manual

Commands

Sending ASCII commands to the gateway will cause the gateway to handle the request but no feedback on the
result is available. The commands will act on all transmitter modules on the same RF channel and group key as
the gateway.
SLEEP <CR> - Sleep all modules that data providers are received from for the sleep duration period. The sleep
duration is set in the T24-Toolkit, see Toolkit – General Settings.
WAKE <CR> - Wake all modules that request to wake for the wake duration period. Sleeping transmitter modules
transmit wake requests every 5 seconds. The wake duration is set in the T24-Toolkit, see Toolkit – General
Settings.
STAYAWAKE <CR> - Issue a stay awake packet to all modules seen for 5 seconds following this command being
executed.
When using RS485 interface issuing commands while the T24-GW1 is outputting is not
possible as the RS485 bus is only half duplex
383
Mantracourt Electronics Limited T24 Telemetry User Manual