Table of Contents
Advertisement
Decode Binary Data Provider (versions 1.06 onwards)
Start Byte
Data Type
Mantracourt Electronics Limited
When the handheld is used with a module that transmits a binary data provider
packet the following two parameters are required to describe how the handheld
should extract a single value to display. The start byte (zero based) specifies where
in the data provider data to start decoding.
Specify the data type to extract. The choices are UINT8, UINT16, INT32 or FLOAT.
You would need to refer to the programmers manual of the appropriate transmitter
module to work out where to extract data from and what type. The default of INT32
with a Start Byte of zero is the default which will be correct for a T24-SAF module.
188
T24 Telemetry User Manual
Advertisement
Table of Contents
