Table of Contents
Advertisement
Installation
Prepare the Host Computer
Follow instructions supplied with Gen5 to install the necessary software.
• Ensure the computer meets the minimum system requirements as described in the
Gen5 Instructions for Use.
• You must have administrator privileges to install Gen5. Log in to Windows as
"Administrator" or consult your IT department for assistance.
Connect the Host Computer and Reader
1. Turn off the computer.
2. Using the supplied USB cable, connect the square end of the cable to the USB port
on the rear of the reader.
3. Connect the other end of the cable to an available USB port on the computer.
4. Turn on the computer.
Install the Power Supply
Power Rating. The instrument's power supply or power cord must be
-WARNING-
connected to a power receptacle that provides voltage and current within
the specified rating for the system. Use of an incompatible power
receptacle may produce electrical shock and fire hazards.
Electrical Grounding. Never use a plug adapter to connect primary power
-WARNING-
to the external power supply. Use of an adapter disconnects the utility
ground, creating a severe shock hazard. Always connect the power cord
directly to an appropriate receptacle with a functional ground.
Power Supply. Use only the power supply shipped with the instrument,
-CAUTION-
and operate it within the range of line voltages listed on it.
1. Connect the power cord to the external power supply.
2. Locate the power inlet on the rear of the reader.
3. Plug the rounded end of the power supply's cord into the power inlet.
4. Plug the other end of the power cord into an appropriate power receptacle.
Agilent BioTek Epoch 2 Instructions for Use
1771011I Revision C
Page 18 of 51
Agilent Technologies, Inc.
Advertisement
Table of Contents
