Tools; Sealant - Profimess SW-08 Operating Instructions Manual

Annex

Sealant

Item No. of
pieces
7 1
8 1
9 1
10 1
11 1
12 1
13 1
11.3

Tools

The following tools are required:
Tools
n Fixed spanner 24, 27 mm
n Flat-bladed screwdriver, width of
blade 5,5 mm
n Hex-screwdriver 2,5 mm
n Torque screwdriver and corre-
sponding blades
n Socket wrench 1/2" and corre-
sponding sockets
Torque wrench 1/2"
n
Special tools
n Threadet ring insertion tool
n Test rod
n O-Ring installation tool
n Magnetic pole tester
76
Description
Threaded ring (outlet)
Process connection (outlet)
Cylinder pin (switch contact)
Switch contact with male connector
Female socket and gasket
Fixing screw (female socket)
Set screw (switch contact)
11.4 Sealant
Before using a sealant, ensure that
it is compatible with the media
used and that it can be employed
under the given operating condi-
tions.
Ensure proper seal
n
Use a suitable sealant. Liquid seal-
n
ants will damage the flow monitor
n Always follow the sealant manu-
facturer's instructions
20.02.2015