Troubleshooting; Safety - Profimess SW-08 Operating Instructions Manual

Troubleshooting

Safety

7 Troubleshooting
This chapter describes possible mal-
functions of the device, their causes
and repair.
If malfunctions persist or increase,
shorten the maintenance interval to
meet the actual operating conditions.
For malfunctions not described in this
chapter, please contact the manufac-
turer (see service address on page 2).
46
7.1 Safety
Work carried out incorrectly to
remedy a malfunction
WARNING!
Risk of injury due to incorrect
repair of malfunction!
Work carried out incorrectly may
result in severe injuries and con-
siderable damage to property.
– Ensure that the site is suffi-
ciently cleared before com-
mencing work
– Ensure that the repair location
is orderly and clean! Compo-
nents and tools that are lying
about or on top of each other
are potential causes of acci-
dents
– If components have been
removed, observe correct
assembly procedures. Rein-
stall all fixing/fastening ele-
ments and observe the pre-
scribed tightening torque for
the screws
Ä Chapter 11.1 "Tightening
torque" on page 74
– Before placing the device back
into operation, ensure that all
work has been carried out and
completed in compliance with
the specifications and instruc-
tions in these Operating
Instructions
20.02.2015