Switch Contact Replacement - Profimess SW-08 Operating Instructions Manual

Maintenance
Maintenance > Switch contact replacement
8.5.4 Switch contact
replacement
Tool:
Flat-bladed screwdriver
n
n Hex screwdriver
Fig. 62: Loosen female socket
Loosen the fixing screw of the
1.
female socket (Fig. 62) with a
flat-bladed screwdriver.
Fig. 63: Remove female socket
2. Remove the female socket and
gasket (Fig. 63) by pulling
upwards.
68
Fig. 64: Loosen set screw
Using a Hex screwdriver,
3.
(Fig. 64) loosen the set screw so
that the switch contact can be
removed.
Fig. 65: Remove switch housing
Remove the switch contact from
4.
the device bodyFig. 65).
Attach the new switch contact,
5.
making sure that the cylinder pin
slides into the guide
6. Insert the set screw and lightly
tighten to still allow the switch
contact to move easily.
23.02.2015