Profimess SW-08 Operating Instructions Manual page 118

Fig. 23: Disconnect inner section
Remove the inner section from
3.
the socket by inserting a flat-
bladed screwdriver into the slot
(Fig. 23/1) and carefully pry out
the inner section.
23.02.2015
Installation and initial startup
Fig. 24: Remove the screw connection
Remove the screw connection
4.
(Fig. 24/1) by turning to the left.
5. Guide the connection cable
through the screw connection
into the socket
Make the connections as shown
6.
in the connection diagram
(Fig. 25 und Fig. 26)
Place the inner section (Fig. 23)
7.
back into the socket and push
until it locks on
8. Re-tighten the screw connection
(Fig. 24/1) by turning it to the
right until tight.
Plug connection
41