Maintenance; Safety; Maintenance Plan - Profimess SW-08 Operating Instructions Manual

Maintenance

Maintenance plan

8 Maintenance

8.1 Safety

Maintenance work performed incor-
rectly
WARNING!
Risk of injury due to mainte-
nance work performed incor-
rectly!
Maintenance work performed
incorrectly may result in severe
injuries and considerable damage
to property.
– Ensure that the site is suffi-
ciently cleared before com-
mencing work.
– Ensure that the repair location
is orderly and clean! Compo-
nents and tools that are lying
about or on top of each other
are potential causes of acci-
dents.
– If components have been
removed, observe correct
assembly procedure. Reinstall
all fixing/fastening elements
and observe the prescribed
tightening torque for the
screws (see Chapter 11.1).
– Before placing the device back
into operation ensure that all
work has been carried out and
completed in compliance with
the specifications and instruc-
tions in these Operating
Instructions.
52
8.2 Maintenance plan
Intervals for replacing wear parts
SW-08 type flow monitors require
very little maintenance due to the small
number of moving parts. The intervals
for the replacement of wear parts
depend significantly on the operating
conditions as well as on the composi-
tion of the medium flowing through the
device. For this reason, no intervals
have been set by the manufacturer.
The operator must determine suitable
intervals based on the local conditions
and circumstances.
23.02.2015