Profimess SW-08 Operating Instructions Manual page 44

Operation
Switch point adjustment
Setting the switch point of a non-
installed device
Fig. 32: Loosen the set screw
1. Loosen the set screw of the
switch contact (Fig. 32/1)using a
Hex-Screwdriver screwdriver.
Slide the switch contact to the
2.
flow value to be monitored.
Make sure that the arrow on the
switch contact data plate is
exactly in alignment with the
desired flow rate on the switch
point adjustment scale.
Re-tighten the set screw of the
3.
switch contact (Fig. 32/1) using
a Hex-Screwdriver. When doing
so, observe the correct tight-
ening torque of the screws.
Ä Chapter 11.1 "Tightening
torque" on page 74
44
ð The set switch point corre-
sponds to the switch-off
point of the switch contact
by decreasing flow.
20.02.2015