Profimess SW-08 Operating Instructions Manual page 310

Maintenance
Maintenance > Assembly
Move the display base plate with
24.
attached plastic housing and
scale until the cut-off value on
the display scale corresponds to
the value on the device body
scale. Align the display base
plate perpendicular to the device
body.
If the value on the display scale
25.
matches with the value set on
the body scale, lock the screws
securing the display base plate,
observing the proper tightening
torque ( Ä Chapter 11.1 "Tight-
ening torque of screws"
on page 85).
Fig. 69
Insert the display cover plate
26.
into the plastic housing and
gently press (Fig. 69) until it
snaps into place.
70
Fig. 70
Fasten the screws securing the
27.
display cover plate, observing
the proper tightening torque
(Fig. 70) ( Ä
ening torque of screws"
on page 85).
Chapter 11.1 "Tight-
23.02.2015