Switch Contact Replacement - Profimess SW-08 Operating Instructions Manual

Maintenance
Maintenance > Switch contact replacement
8.5.4 Switch contact
replacement
Tool:
Flat-bladed screwdriver
n
n Hex screwdriver
Fig. 54: Loosen female socket
Loosen the fixing screw of the
1.
female socket (Fig. 54) with a
flat-bladed screwdriver.
Fig. 55: Remove the female socket
2. Remove the female socket and
gasket (Fig. 55) by pulling
upwards.
64
Fig. 56: Loosen set screw
Using a Hex screwdriver
3.
(Fig. 56) remove the set screw
of the switch contact
Fig. 57: Remove switch housing
Remove the switch contact from
4.
the guide surface (Fig. 57).
Attach the new switch contact,
5.
making sure that the cylinder pin
slides into the guide.
6. Insert the set screw and tighten
just enough to still allow the
switch contact to move easily.
20.02.2015