Profimess SW-08 Operating Instructions Manual page 308

Maintenance
Maintenance > Assembly
Fig. 65: Check for smooth operation
Check the float for ease of
14.
movement (Fig. 65) by applying
pressure with the test rod
ð If the float moves sluggishly,
then disassemble the device
Ä Chapter 9.2 "Disas-
sembly" on page 74 and
clean the float and device
body bore
If the float is still slug-
gish after having been
cleaned several times,
contact the manufac-
turers.
68
Fig. 66
Set the display base plate on the
15.
device body and tighten the
mounting screws so that they
can still move. (Fig. 66). Make
sure that the countersunk head
screw is used for the long
groove (area pointer tip) and the
two (2) cylinder head screws are
used for the base center.
Fig. 67
16. Place the plastic housing on the
display base plate and press
down until it snaps into place.
(Fig. 67)
23.02.2015