Parts Replacement; Assembly - Profimess SW-08 Operating Instructions Manual

Maintenance
Maintenance > Assembly
CAUTION!
Risk of injury due to damaged
parts!
If parts of the device are broken or
damaged, they may cause injury
due to sharp edges or splinters
during the cleaning process.
– Damaged parts must be
replaced
– Carefully clean the parts of the
device, so as not to cause
damage.
– When cleaning, always wear
appropriate personal protec-
tive equipment.
– Incorrect disassembly can
result in injuries.
58
Protective equipment:
n With hazardous media, the protec-
tive equipment specified in the
Safety Data Sheet of the medium
must be worn. In addition, the
specifications of the system oper-
ator must be followed. If no protec-
tive equipment is specified, suit-
able protective gloves and goggles
must be worn.

8.5.2 Parts replacement

Depending on the operating conditions,
wear parts such as O-rings, float or
magnets may have to be replaced.
Steps required to replace these parts
correspond to those used when
assembling the device
"Assembly" on page 58.

8.5.3 Assembly

After cleaning the individual compo-
nents, the flow monitor must be reas-
sembled.
Ä Chapter 8.5.3
20.02.2015