Profimess SW-08 Operating Instructions Manual page 285

Setting the switch point of a non-
installed device
Fig. 33: Loosen the set screws
1. Loosen the set screws of the
switch contact (Fig. 33/1) using
a flat-bladed screwdriver.
Set the switch contact to the flow
2.
value to be monitored. Make
sure that the arrow on the switch
contact data plate is exactly in
alignment with the desired flow
rate on the switchpoint adjust-
ment scale.
Re-tighten the set screws of the
3.
switch contact (Fig. 33/1) using
a flat-bladed screwdriver. When
doing so, observe the correct
tightening torque of the screws.
Ä Chapter 11.1 "Tightening
torque of screws" on page 85
23.02.2015
ð The set switch point corre-
sponds to the switch-off
point of the switch contact
by decreasing flow.
Operation
Setting the switch point
45