Profimess SW-08 Operating Instructions Manual page 33

Install device in pipe system
Personnel:
Qualified personnel
n
Protective equipment:
n Protective gloves
Tool:
n Fixed spanner
CAUTION!
Do not hold the device by its
threads. These are sharp edged
and may cause injury.
Start the threaded end of the
1.
device onto the thread of the
connecting pipe
Fig. 11: Screw in the device
2. Fasten the adapter union of the
pipeline with an appropriate
spanner (Fig. 11/2). When doing
so, lock the process connector in
place to prevent slip, using a
suitable spanner (Fig. 11/1).
20.02.2015
Installation and initial startup
Fig. 12: Screw in the device
Keep turning in the adapter
3.
union (Fig. 12/1) while holding
the process connection of the
device locked (Fig. 12/2) until
the connection is tight.
Repeat these steps at the other
4.
end of the device.
Installation in the pipe system
33