Parts Replacement; Assembly - Profimess SW-08 Operating Instructions Manual

Maintenance
Maintenance > Assembly
Protective equipment:
n With hazardous media, the protec-
tive equipment specified in the
Safety Data Sheet of the medium
must be worn. In addition, the
specifications of the system oper-
ator must be followed. If no protec-
tive equipment is specified, suit-
able protective gloves and goggles
must be worn.

8.5.2 Parts replacement

Depending on the operating conditions,
wear parts such as O-rings, float or
magnets may have to be replaced.
Steps required to replace these parts
correspond to those used when
assembling the device
"Assembly" on page 60.

8.5.3 Assembly

After cleaning the individual compo-
nents, the flow monitor must be reas-
sembled.
60
Ä Chapter 8.5.3
Personnel:
n Qualified personnel
Tool:
Flat-bladed screwdriver
n
n Torque screwdriver and assorted
blades
Fixed spanner
n
n Socket wrench
n Torque wrench
Special tools:
n Threaded ring insertion tool
n Test rod
n O-Ring installation tool
n Magnetic pole indicator
Fig. 46: O-ring (seal)
23.02.2015