Note
Replace the self-locking nuts and screws when undertaking
♦
assembly work.
Replace screws which have been tightened to a torquing angle
♦
as well as gasket rings and seals.
Check whether the dowel sleeves for centering the gearbox
♦
are present in the cylinder block, insert if necessary.
Secure all hose connections with hose clamps which comply
♦
with the series design ⇒ Electronic Catalogue of Original
Parts .
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
Before installing the gearbox one should ensure that the tor‐
♦
que converter is correctly installed in the gearbox
⇒ "1.4 Installing the torque converter", page 18
If the battery earth strap is disconnected and connected, carry
♦
out additional operations ⇒ Electrical System; Rep. gr. 27 .
Caution
If the converter is installed wrongly the driver of the torque
converter or the ATF pump will be destroyed when the gearbox
on the engine is connected at its flange.
– Inspect ATF level, if necessary top up with ATF
⇒ "4 ATF", page 147
– Inspect setting of selector lever control cable and adjust if
necessary
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 55
.
– Check coolant level in the cooling system ⇒ Engine; Rep. gr.
19 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 09G - Edition 07.2014
.
3. Removing and installing the gearbox
133