Table of Contents
Advertisement
EDITION 02/2016
OPERATING MANUAL
1. Loosen the oval head screw (3).
2. Pull the air valve (4) out off the drilled hole. Do not turn!
Do not damage the cylindrical surfaces. Ideally press
on the tappet from behind using a transversely held
screwdriver, for example.
3. Only as required:
Press out seal (5) using a handle seal assembly tool
(Order No. 2342334, not included in scope of delivery).
10.4.3
CLEANING THE PARTS AFTER DISASSEMBLY
Please note:
All reusable parts (except for the electrical components) should be cleaned
thoroughly using a suitable cleaning agent.
The adapter, plug, inside handle and all dismantled parts must be clean and dry
after cleaning. Care should be taken that these parts remain free of solvents, grease
or sweat from the hands (salt water). Clean and mount wearing gloves.
Spare parts may have safety-relevant properties.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Defective parts, O-rings and seal sets must always be re-placed.
Incompatibility of cleaning agent and working medium!
Risk of explosion and danger of poisoning by toxic gases.
In Chapter 14 the part numbers for gun spare parts can be found as well as for wearing parts
such as seals.
ORDER NUMBER DOC 2366600
ATTENTION
WARNING
Examine the compatibility of the cleaning agents and working
media on the basis of the safety data sheets.
9
4
SW5
5
Torx® 20
3
B_04788
107
Advertisement
Table of Contents
