Display During Spraying - WAGNER AquaCoat 5010 Translation Of The Original Operating Manual

EDITION 02/2016
OPERATING MANUAL
7.3.15

DISPLAY DURING SPRAYING

Ready to spray using R2 recipe (see picture below).
Control unit in standby position.
The nominal value LEDs illuminate as dots and the high-voltage value is digitally displayed
in the LED display. If you press the current limiter push button, the set nominal value for
the spray current limiter is digitally displayed in the LED display.
Spraying using recipe R2:
High voltage is created by pressing the trigger on the spray gun. The LEDS then illuminate
as bar displays and show the actual values. The current actual value of the activated push
button for the high voltage (kV) is digitally displayed on the LED display. If the push button
for the spray current limiter is pressed, the relevant LED lights up and the corresponding
actual value in μA appears in the LED display.
ORDER NUMBER DOC 2366600
80 100
60 80
R1
40 60
20 40
R2
10 20
kV μA
R3
80 100
60 80
R1
40 60
20 40
R2
10 20
kV μA
R3
POWER POWER
0 1
AquaCoat
B_03379
POWER POWER
0 1
AquaCoat
B_03380
80