Table of Contents
Advertisement
4.2
Cleaning the spray gun and replacing the wearing parts
Caution
Never place the spray gun or parts of the spray gun in cleaning agent!
When pulling out and inserting the parts, ensure that the charging body is not damaged!
4.2.1 Replacing the charging body
2
A
25
It is also possible to dismantle the charging body and merely replace the parts affected by
wear.
16
18
•
Carefully push the nozzle body 20/32 over the powder tube 25 and tighten on the gun
housing B using the outer nut 2.
•
Slide the deflector cone A back over the charging body L.
18
L
20/32
B
22
26
23
24
0351701
•
Pull the deflector cone A off the
charging body L.
•
Unscrew the outer nut 2 from the gun
housing B.
•
Pull the nozzle body 20/32 off the
powder tube 25.
•
Carefully extract the charging body L
out of the powder tube 25.
•
Check the removed parts for wear. The
entire charging body can be replaced
with a new one during this procedure.
Peat3xl_0005b
•
Unscrew the tip 28 from the threaded
bar 22.
•
Carefully pull the parts 24 to 26 off the
threaded rod 22.
•
As a rule you only need to check the
parts 24 to 26 for wear and replace
them as necessary.
•
Clean all parts that have not been
28
subject to wear.
•
Unscrew the air nozzle 16 from the
deflector cone rod 18 if worn and
replace it with a new one.
•
Reassemble the charging body L and
Peat3_0005c
carefully push it into powder tube 25.
- PEA-T3XL
Maintenance and cleaning
0402_Peat3xl_Verschleiss.doc
0402_Peat_Verschleiss.doc
05 / 2009
Advertisement
Table of Contents
