Access To The Device Configuration Mode - WAGNER AquaCoat 5010 Translation Of The Original Operating Manual

EDITION 02/2016
OPERATING MANUAL
7.4.2

ACCESS TO THE DEVICE CONFIGURATION MODE

80 100
60 80
R1
40 60
20 40
R2
10 20
kV μA
R3
4 3
80 100
60 80
R1
60
40
20 40
R2
10 20
kV μA
R3
80 100
60 80
R1
40 60
20 40
R2
10 20
kV μA
R3
8 6 4
ORDER NUMBER DOC 2366600
Procedure:
POWER POWER
0 1
AquaCoat
B_03381
25 27
POWER POWER
0 1
AquaCoat
B_03507
2
27
POWER POWER
0 1
AquaCoat
B_03508
1. Switch device to "Standby" by pressing
the "Standby" key (3).
The "Standby" LED (4) lights up yellow.
2. Press and hold the "Service" push
button (25).
3. Turn the universal control dial (2) with
the other hand until the LED display (27)
shows the number "10". Then release
the "Service" button (25). The running
text "confi guration" is displayed in the
LED display (27).
The device is now in confi guration
mode.
4. The fi rst confi guration parameter C11 is
now displayed in the LED display (27).
The two LED displays "Spray Current" (6)
and "High Voltage" (8) fl ash at the same
time.
The "Standby" (4) LED display fl ashes
quickly.
Note:
The C11 parameter can be changed, but
this will not have any eff ect.
86