Table of Contents
Advertisement
EDITION 02/2016
OPERATING MANUAL
In the event of skin injuries caused by paint or fl ushing agents:
Note the paint or fl ushing agent that you have been using.
Consult a doctor immediately.
Avoid risk of injury from recoil forces:
Ensure that you have firm footing when operating the spray gun.
Only hold the spray gun briefl y in a position.
4.2.2
GROUNDING THE DEVICE
Friction, fl owing liquids and air or electrostatic coating processes create charges. Flames or
sparks can form during discharge. Grounding prevents electrostatic charging.
Ensure that the device is grounded.
Ground the work pieces to be coated.
Ensure that all persons inside the working area are grounded, e.g., that they are wearing
static dissipative shoes.
Wear static dissipative gloves when spraying. The grounding takes place via the spray
gun handle or the trigger guard.
4.2.3
PRODUCT HOSES
Ensure that the hose material is chemically resistant to the sprayed products and the
fl ushing agents used.
Ensure that the product hose is suitable for the pressure generated.
Ensure that the following information can be seen on the high-pressure hose:
- Manufacturer
- Permissible operating pressure
- Date of manufacture
Make sure that the hoses are laid only in suitable places. Hoses should not be laid in the
following places under any circumstances:
- in high-traffic areas,
- on sharp edges,
- on moving parts or
- on hot surfaces.
Ensure that the hoses are never run over by vehicles (e.g., fork lifts), or that the hoses are
never put under pressure from the outside in any other way.
Ensure that the hoses are never kinked. Observe maximum bending radii.
Make sure that the hoses are never used to pull or move the equipment.
The electrical resistance of the product hose outer sheath, measured over the entire
length of the outer sheath, must be less than 1 megohm.
Suction hoses may not be subjected to pressure.
ORDER NUMBER DOC 2366600
See chapter "Grounding".
17
Advertisement
Table of Contents
