Table of Contents
Advertisement
EDITION 02/2016
OPERATING MANUAL
7.3.2
STARTING THE SYSTEM
Zerstäuberluft
Mat. Druckregler
Atomizing air
Mat. pressure reg.
11
10
VM 5020W control unit
1. Set the main switch (1) to position 1.
During the start-up phase, the device automatically performs an internal function
test and then automatically switches to recipe 1 (15).
2. Set the desired recipe.
See Chapter 7.3.11 and the following for information on how to operate the control unit.
Product supply
3. Open the compressed air supply.
4. Adjust the product supply to approximately 8 MPa; 80 bar; 1160 psi of operating pressure (10).
Spray gun
5. Open atomizing air regulator (11) (approximately 0.05-0.25 MPa; 0.5-2.5 bar; 7-36 psi).
6. Release the spray gun.
7. Spray on a test object (pull trigger).
If the trigger guard is now actuated at the spray gun, the high voltage is switched on
and both displays (21) and (22) change from dot to bar display, i.e. the actual value
of the high voltage (21) and the actual value of the spray current (22) are displayed.
The high voltage can be switched on and off with the push button (3).
8. Adjust the pump pressure regulator (9) and atomizing air regulator (11) with respect to
the nozzle and object
9. Secure the spray gun with the trigger lock.
ORDER NUMBER DOC 2366600
15
21
22
80
100
60
80
R1
40
60
20
40
R2
Pumpe
10
20
Pump
kV
μA
R3
B_03371
9
3
see Chapter 7.3.3.
POWER
0
1
AquaCoat
1
B_05900
66
Advertisement
Table of Contents
