Cleaning The Parts After Disassembly - WAGNER GM 5000EAC Operating Manual

EDITION 03/2012
OPERATING MANUAL
6.4

CLEANING THE PARTS AFTER DISASSEMBLY

Please note:
➞ All reusable parts (except for the parts that conduct the high-voltage such as cascade,
end piece, plug compl. etc.) should be cleaned thoroughly using a suitable cleaning
agent.
➞ The end piece, plug compl. and the handle inside must be clean and dry after
cleaning. Care should be taken that these parts remain free of solvents, grease or
sweat from the hands (salt water).
➞ Only spare parts are used which have undergone an EC type examination
and are subject to a quality assessment (production monitoring) according to
Directive 94/9/EC.
➞ Spare parts may have safety-relevant properties.
➞ Defective parts, O-rings and seal sets must always be re-placed.
Incompatibility of cleaning agent and working medium!
Risk of explosion and danger of poisoning by toxic gasses
SIHI_0060_GB
In chapter 10 can be found part numbers for gun spare parts as well as for wearing parts
such as seals.
PART NUMBER DOC 2319150
ATTENTION
Check the compatibility of cleaning agent and working medium
in accordance with safety data sheets.
WARNING
GM 5000EAC.
41