Table of Contents
Advertisement
6.3.8 Notes on input and output pins
(1) Fix of a port input level in stand-by state
In stand-by state
port "undefined," especially for I/O ports of the P-channel and the N-channel open-drain.
Pull-up (connect the port to V
When determining a resistance value, note the following points:
External circuit
Variation of output levels during the ordinary operation
When using built-in pull-up or pull-down resistor, note on varied current values.
When setting as an input port : fix its input level
When setting as an output port : prevent current from flowing out to external
Reason
Even when setting as an output port with its direction register, in the following state :
N-channel......when the content of the port latch is "1"
the transistor becomes the OFF state, which causes the ports to be the high-impedance state. Note
that the level becomes "undefined" depending on external circuits.
Accordingly, the potential which is input to the input buffer in a microcomputer is unstable in the
state that input levels of a input port and an I/O port are "undefined." This may cause power source
current.
2 stand-by state : the stop mode by executing the STP instruction
(2) Modify of the contents of I/O port latch
When the port latch of an I/O port is modified with the bit managing instruction
unspecified bit may be changed.
Reason
The bit managing instructions
by a byte unit. Accordingly, when these instructions are executed on a bit of the data register of an
I/O port, the following is executed to all bits of the data register.
As for a bit which is set for an input port :
The pin state is read in the CPU, and is written to this bit after bit managing.
As for a bit which is set for an output port :
The bit value is read in the CPU, and is written to this bit after bit managing.
Note the following :
Even when a port which is set as an output port is changed for an input port, its data register holds
the output data.
As for a bit of which is set for an input port, its value may be changed even when not specified
with a bit managing instruction in case where the pin state differs from its data register contents
3 bit managing instructions : SEB, and CLB instruction
6.3.9 Note on JMP instruction
When using the JMP instruction (the indirect addressing mode), do not specify the last address in a page
as an indirect address.
Memory (addresses 0000
2
for low-power dissipation, do not make input levels of an input port and an I/O
) or pull-down (connect the port to V
CC
the wait mode by executing the WIT instruction
3
are read-modify-write form instructions for reading and writing data
to FFFF
) is separated into pages (by each 256 address).
16
16
7220 Group User's Manual
APPENDIX
6.3 Notes on use
) these ports through a resistor.
SS
3
, the value of the
6-9
Advertisement
Table of Contents
