Renesas 7200 Series User Manual page 55

FUNCTIONAL DESCRIPTION
2.5 Interrupts
(7) Timer 3 interrupt
Timer 3 value is counted down. Timer 3 interrupt request occurs when the count source next to "00
is input.
(8) Timer 2 interrupt
Timer 2 value is counted down. Timer 2 interrupt request occurs when a count source next to "00
is input
(9) Timer 1 interrupt
Timer 1 value is counted down. Timer 1 interrupt request occurs when a count source next to "00
is input.
(10) Serial I/O interrupt
The serial I/O interrupt request is generated by detecting a rising edge of the eighth serial transfer
clock after writing to the serial I/O register.
(11) Multi-master I
A multi-master interrupt request occurs synchronized with a falling edge serial clock (SCL) every
completion of 1-byte data communication.
(12) INT3 interrupt
An INT3 interrupt request is generated by detecting a transition in the level on pin INT3 (external
interrupt input).
Detecting either positive polarity (LOW to HIGH transition) or negative polarity (HIGH to LOW transition)
to be detected is set with RE5 (the interrupt input polarity register: bit 5 at address 00F9
RE5 is set to "0," a positive polarity is detected, when RE5 is set to "1," a negative polarity is
detected.
Pin INT3 is also used for port P1
may cause software runaway. Therefore, when this pin is used as port P1
by using an interrupt enable bit and interrupt disable flag (1).
(13) BRK instruction interrupt
This software interrupt has the least significant priority and generates an interrupt request is generated
by executing when the BRK instruction. There is no corresponding interrupt enable bit and no
influence by the interrupt disable flag (I).
2-28
2
C-BUS interface interrupt
and pin A-D1. An INT3 interrupt by a level transition on the pin
5
7220 Group User's Manual
). When
16
, disable an INT3 interrupt
5
"
16
"
16
"
16