Renesas 7200 Series User Manual page 78

2
(3) I C clock control register (S2: address 00DB
2
The I C clock control register (address 00DB
frequency.
Bits 0 to 4: SCL frequency control bits (CCR0–CCR4)
These bits control the SCL frequency. Refer to "Table 2.8.4."
Bit 5: SCL mode specification bit (FAST MODE)
This bit specifies the SCL mode. When this bit is set to "0," the standard clock mode is set. When
the bit is set to "1," the high-speed clock mode is set.
Bit 6: ACK bit (ACK BIT)
This bit sets the SDA status when an ACK clock is generated. When this bit is set to "0," the ACK
return mode is set and SDA goes to LOW at the occurrence of an ACK clock. When the bit is set
to "1," the ACK non-return mode is set. The SDA is held in the HIGH status at the occurrence of
an ACK clock.
However, when the slave address matches the address data in the reception of address data at
ACK BIT = "0," the SDA is automatically made LOW (ACK is returned). If there is a mismatch
between the slave address and the address data, the SDA is automatically made HIGH (ACK is
not returned).
ACK clock: Clock for acknowledgment
Bit 7: ACK clock bit (ACK)
This bit specifies a mode of acknowledgment which is an acknowledgment response of data
transmission. When this bit is set to "0," the no ACK clock mode is set. In this case, no ACK clock
occurs after data transmission. When the bit is set to "1," the ACK clock mode is set and the
master generates an ACK clock upon completion of each 1-byte data transmission. The device for
transmitting address data and control data releases the SDA at the occurrence of an ACK clock
(make SDA HIGH) and receives the ACK bit generated by the data receiving device.
Figure 2.8.4 shows the I
Note: Do not write data into the I
transmission, the I
FUNCTIONAL DESCRIPTION
2 C clock control register.
2
C clock control register during transmission. If data is written during
2
C clock generator is reset, so that data cannot be transmitted normally.
7220 Group User's Manual
2.8 Multi-master I
)
16
) is used to set ACK control, SCL mode and SCL
16
2 C-BUS interface
2-51