Table of Contents
Advertisement
APPLICATION
2
5.5 Example of I
C-BUS control by software (M37220M3-XXXSP/FP)
Bit 0: Color system determination bit 0 (CONDITION)
This bit indicates whether the color system is being determined or not. Figure 5.5.16 shows the
state of determination, according to the bit, when AUTO (bit 5 at sub-address 06
set to "1." When AUTO (bit 5 at sub-address 06
color system is not determined automatically.
Bit 1: Color system determination bit 1 (SECAM)
Bit 2: Color system determination bit 2 (NTSC)
These bits determine the color system.
Bit 3: 3.58/4.43 determination bit (3.58)
This bit determines whether a color signal sub-carrier of the color system is 3.58 MHz or 4.43 MHz.
Bit 4: AFT signal detection bit 0 (AFT0)
Bit 5: AFT signal detection bit 1 (AFT1)
These bits detect the level of the auto fine tuning signal.
Bit 6: Synchronous presence determination bit (COINCIDENCE)
This bit determines whether Pin H.OUT output is synchronized with the video signal or not.
Bit 7: Field Frequency determination bit (50/60)
This bit determines whether the field frequency is 50 Hz or 60 Hz. According to the state of this
bit, the display position or a vertical direction size of video can be changed.
5-40
, write data) is set to "0," bit 0 is invalid as the
16
7220 Group User's Manual
, write data) is
16
Advertisement
Table of Contents
