Table of Contents
Advertisement
Preparing for Initial Use of Your New FieldFox
FieldFox ON/OFF Settings
— On the battery. Open the FieldFox battery compartment door to view the
To conserve battery power:
— Use Run/Hold to single-trigger a measurement when needed.
— Press System then
— Briefly press the power button to switch to Standby mode when the
When powered by the battery only, the FieldFox can stay in Standby mode
for a maximum of four hours and then it powers off automatically. When
the relative battery charge drops by about 20%, the FieldFox will power off
to preserve the remaining charge.
To recharge a battery:
Use ONLY a FieldFox charger to recharge a battery.
— The battery can be fully charged while in the FieldFox in about 4 hours with
— The battery can be fully charged externally using the external battery
— When the battery is removed, the FieldFox can still be powered by the
FieldFox ON/OFF Settings
The FieldFox power button shut down/standby sequence includes a 10
second counter that allows you to either choose a softkey to immediately
initiate the action
counter expire after 10 seconds then perform the action.
*Restart can only be enabled via the
— To turn power ON, briefly press the power button. Boot-up takes about 1
— To switch to Stand by mode (low battery drain), briefly press the power
Keysight N9912-90001 User's Guide
battery LCD.
shown on the display.
Display
rotary knob, or numeric keypad to adjust the brightness to dim the FieldFox
display as much as possible.
FieldFox is not being used.
preserved.
the FieldFox either ON or OFF.
charger (Opt 872) in about 4 hours.
AC/DC adapter.
Stand by
(
minute.
button. See the Note above concerning Stand By.
then Brightness. Use the
Press again to restore power. All current settings are
Shut down
Restart*)
/
/
Restart
softkey.
Hold
is
arrows, the
or to let the countdown
,
2- 3
Advertisement
Table of Contents
