ipf electronic opti-check Technical Documentation Manual page 77

Technical Documentation
opti-check
NOTE
The device names and device location can be edited under Device → Device settings →
Device name.
NOTE
You can launch the Application Suite using a command line parameter and automatically
connect to the device via an IP address.
Example: appsuite2.exe /ip=192.168.0.250 (default IP address)
There is also the option to launch the Application Suite in different languages using a
command line parameter.
/l=de (German)
/l=en (English)
/l=fr (French)
Example: appsuite2.exe /ip=192.168.0.250 /l=en
(Start the Application Suite in English with the default IP address)
NOTE
Should the device no longer be reachable due to adverse factors (e.g. corrupt job data),
and cannot be rebooted into Recovery mode independently, it can normally be forced to
start in Recovery mode by starting the Application Suite with the following command line
parameters:
appsuite2.exe /ip=<device IP address> /rebootrecovery
This process normally takes a little over a minute. Once complete, the device will be in
Recovery mode and jobs can be deleted, device settings can be changed or new
firmware can be loaded.
v2.8.2-K11 77/332 ipf electronic GmbH
Lüdenscheid, Germany