Sj Command - Change To A Different Job - ipf electronic opti-check Technical Documentation Manual

15.4.9 SJ command – change to a different job
This function enables you to change to a different job.
To use this function, you must first activate the option Command SJ via process interface in the device
settings.
Example
Structure of the command PLC
Command Parameters
S J 0
Switch Job
4 byte ASCII hex
desired job number
Structure of the Response PLC
Response
R S 0
Response 4 byte ASCII hex
State Status
NOTE
Further explanation of the parameters of the RS response can be found under "Request
status (GS / RS)".
v2.8.2-K11
device
0 1 A
device
0 8 5
4 byte ASCII hex
Number of the active job
0 0 1 A
281/332
Technical Documentation
opti-check
ipf electronic GmbH
Lüdenscheid, Germany