MultiTrode MultiSmart Installation & Operation Manual page 91
Pump station manager & rtu
Hide thumbs
Also See for MultiSmart:
- Installation & operation manual (260 pages) ,
- Integrator manual (20 pages)
Table of Contents
Advertisement
MultiSmart Installation & Operation Manual
Digital Input configuration - for reference only:
Type of Input
Conductive Probe
Seal Sensor (conductive)
Flygt CLS
PTC Thermistor
Flygt FLS
Normal Volt Free Contact Closure
Failsafe Probe Sensor
High Speed Counter
Table 9 – Digital Input Mode Examples
14.4.2
Digital Input Summary Table
This table summarizes the capabilities of the digital inputs on the pump controller (3PC) board:
Volt
Free
DIN#
Input
Mode
Digital
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Table 10 – Digital Input Capabilities
MultiSmart_IO_Manual_A4_v2-22_R15.doc
Mode
AC
AC
CLS
DC
DC
Digital
Fail Safe
High Speed
PTC Thermistor,
Conductive
Seal Sensor,
Probe
Flygt FLS
DC
AC
Typical Sensitivity or Range
20,000Ω
40,000Ω
Seal >4kΩ, Thermal <1kΩ
3,000Ω
Seal >4kΩ, Thermal <545Ω
4Hz
4,000Ω
1kHz
Low Speed
High Speed
Counter
Counter
(4Hz)
(1kHz)
Digital
High Speed
Invert?
No
No
No
Yes
No
No (default) / Yes (N/C)
No
No (default) / Yes
Fail Safe
Flygt CLS
Probe
CLS
FailSafe
Page 91 of 201
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSmart and is the answer not in the manual?
Questions and answers
I have four pumps connected to my multi smart. One jockey and three that rotate with the jockey as needed. My problem is that the jockey pump always shows its running even when it isn't running. the other pumps show actuate run times and starts. only the main pump shows continuous run even when it is turned off. I was wondering if there any advice I could be given to resolve this issue.
The MultiTrode MultiSmart may show the jockey pump as continuously running even when it is turned off due to the "External Run" status. This occurs if the pump is started by an external control method, such as a manual override switch, where the contactor remains closed but no run command was sent by the controller. As a result, the system continues updating run time statistics and generating relevant faults or warnings. Checking for an external control signal or a stuck contactor may help resolve the issue.
This answer is automatically generated