MultiTrode MultiSmart Installation & Operation Manual page 73
Pump station manager & rtu
Hide thumbs
Also See for MultiSmart:
- Installation & operation manual (260 pages) ,
- Integrator manual (20 pages)
Table of Contents
Advertisement
MultiSmart Installation & Operation Manual
To edit, add or delete a user press Add/Remove Users
The following user settings can be edited:
User ID
•
PIN
•
User Name
•
User ID
1
2
3
Back
Figure 81 – Edit User Security Details
To change the administrator password:
Press Administrator Settings
•
Enter a new password
•
•
Press Save
Figure 82 – Change Administrator Password
MultiSmart_IO_Manual_A4_v2-22_R15.doc
Edit User Details
PIN
User Name
DonaldF
1234
PaulO
5678
StuartD
9012
Add New
Delete
Cancel
User
Edit
Save
Page 73 of 201
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSmart and is the answer not in the manual?
Questions and answers
I have four pumps connected to my multi smart. One jockey and three that rotate with the jockey as needed. My problem is that the jockey pump always shows its running even when it isn't running. the other pumps show actuate run times and starts. only the main pump shows continuous run even when it is turned off. I was wondering if there any advice I could be given to resolve this issue.
The MultiTrode MultiSmart may show the jockey pump as continuously running even when it is turned off due to the "External Run" status. This occurs if the pump is started by an external control method, such as a manual override switch, where the contactor remains closed but no run command was sent by the controller. As a result, the system continues updating run time statistics and generating relevant faults or warnings. Checking for an external control signal or a stuck contactor may help resolve the issue.
This answer is automatically generated