Advanced Functions - MultiTrode MultiSmart Installation & Operation Manual
Pump station manager & rtu
Hide thumbs
Also See for MultiSmart:
- Installation & operation manual (260 pages) ,
- Integrator manual (20 pages)
Table of Contents
Advertisement
25.5 Advanced Functions
Function
sin
cos
tan
asin
acos
atan
sinh
cosh
tanh
log2
log10
ln
log
exp
sqrt
sign
round
floor
ceil
mod
abs
min
max
sum
avg
if
Table 34 – Logic Engine Advanced Functions
Page 178 of 201
MultiSmart Installation & Operation Manual
Description
Sine
Cosine
Tangent
Arc sine
Arc cosine
Arc tangent
Hyperbolic sine
Hyperbolic cosine
Hyperbolic tangent
logarithm to the base 2
logarithm to the base 10
logarithm to the base e
logarithm to the base 10
e raised to the power of x
Square root
-1 if x<0; 1 if x > 0
round to nearest integer
Round down to nearest integer
Round up to nearest integer
Modulus
absolute value
minimum of an unlimited parameter list
maximum of an unlimited parameter list
sum of an unlimited parameter list
average of unlimited parameter list
if ... then ... else e.g. if (10 > 1, 1, 0) if arg1, then arg2 else arg3
MultiSmart_IO_Manual_A4_v2-22_R15.doc
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSmart and is the answer not in the manual?
Questions and answers
I have four pumps connected to my multi smart. One jockey and three that rotate with the jockey as needed. My problem is that the jockey pump always shows its running even when it isn't running. the other pumps show actuate run times and starts. only the main pump shows continuous run even when it is turned off. I was wondering if there any advice I could be given to resolve this issue.
The MultiTrode MultiSmart may show the jockey pump as continuously running even when it is turned off due to the "External Run" status. This occurs if the pump is started by an external control method, such as a manual override switch, where the contactor remains closed but no run command was sent by the controller. As a result, the system continues updating run time statistics and generating relevant faults or warnings. Checking for an external control signal or a stuck contactor may help resolve the issue.
This answer is automatically generated