MultiTrode MultiSmart Installation & Operation Manual page 28

Some of the settings require a reboot of the MultiSmart unit for it to come into effect after the change, where
as a few others come into effect as soon as the changes are saved. If a restart is required MultiSmart
prompts the user with three options, Restart Now, Restart Later and Continue as shown in the figure
below.
Figure 24 – Reboot Screen
If Restart Now is selected the unit saves the current values and reboots immediately before any further
configuration changes can be performed. If further configuration changes are needed, choose Restart Later
or Continue.
If Restart Later is selected the MultiSmart resumes normal operation, however the new changes do not
come into effect until after a reboot, and the restart prompt is no longer displayed. A fault is displayed on the
main screen to remind the user that a reboot is required.
The Continue option is similar as it also prevents an immediate reboot of the unit but a restart prompt is
displayed for every subsequent change to the configuration..
NOTE:
The restart option in some cases is not displayed. For example, for some major changes like adding a
new DNP slave profile, the MultiSmart skips the restart option prompt and performs an immediate
reboot to bring the new changes into effect immediately.
Page 28 of 201
MultiSmart Installation & Operation Manual
MultiSmart_IO_Manual_A4_v2-22_R15.doc