MultiTrode MultiSmart Installation & Operation Manual page 136

Pump station manager & rtu
Hide thumbs Also See for MultiSmart:
Table of Contents

Advertisement

Each Supply Protection fault described above has the following configuration settings:
Name
Enabled?
Threshold
Act Delay (sec)
Deact Delay (sec)
Fault Station?
Manual Reset Required?
Table 24 – Supply Protection Fault Parameters
Page 136 of 201
MultiSmart Installation & Operation Manual
Description
Enables or disables the fault.
Sets a threshold where it is relevant. When this is reached a fault condition is
activated.
Activation delay in seconds. This sets how many seconds to wait after a fault has
been detected before an alarm condition is raised.
Deactivation delay in seconds. Sets how many seconds to wait before deactivating
an alarm condition after the fault condition is no longer present.
Sets whether to fault the station when a fault is detected
Sets whether a Manual Reset is required after a fault condition has been detected.
MultiSmart_IO_Manual_A4_v2-22_R15.doc

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MultiSmart and is the answer not in the manual?

Related Products for MultiTrode MultiSmart

Table of Contents

Save PDF