MultiTrode MultiSmart Installation & Operation Manual page 80
Pump station manager & rtu
Hide thumbs
Also See for MultiSmart:
- Installation & operation manual (260 pages) ,
- Integrator manual (20 pages)
Table of Contents
Advertisement
Use the arrows to select an alarm
•
Enter new values using the keypad
•
Push the Save button to commit the changes
•
If the settings are invalid an error message is displayed
•
NOTE: In the case of a configuration for more than one well, a well selector will appear in the
upper left of the LCD screen.
12.3.5
Enable/Disable Alarms
From the main screen navigate to the Level Alarms screen:
Figure 91 - Enable/Disable Alarms
Use the arrows to select an alarm
•
Use the Enable/Disable button to select or unselect each alarm.
•
Push the Save button to commit the changes
•
Page 80 of 201
MultiSmart Installation & Operation Manual
MultiSmart_IO_Manual_A4_v2-22_R15.doc
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSmart and is the answer not in the manual?
Questions and answers
I have four pumps connected to my multi smart. One jockey and three that rotate with the jockey as needed. My problem is that the jockey pump always shows its running even when it isn't running. the other pumps show actuate run times and starts. only the main pump shows continuous run even when it is turned off. I was wondering if there any advice I could be given to resolve this issue.
The MultiTrode MultiSmart may show the jockey pump as continuously running even when it is turned off due to the "External Run" status. This occurs if the pump is started by an external control method, such as a manual override switch, where the contactor remains closed but no run command was sent by the controller. As a result, the system continues updating run time statistics and generating relevant faults or warnings. Checking for an external control signal or a stuck contactor may help resolve the issue.
This answer is automatically generated