LEGRAND Server Technology PRO3X User Manual page 74

Determining the SSH Authentication Method
This command syntax determines the SSH authentication method.
config:# network services ssh authentication <auth_method>
Variables:
<option> is one of the options: passwordOnly, publicKeyOnly or passwordOrPublicKey.
Option
passwordOnly
publicKeyOnly
passwordOrPublicKey
If the public key authentication is selected, you must enter a valid SSH public key for each user profile to log in over the SSH
connection.
Setting the SNMP Configuration
You can enable or disable the SNMP v1/v2c or v3 agent, configure the read and write community strings, or set the MIB-II
parameters, such as sysContact, using the CLI commands.
An SNMP command begins with network services snmp.
Enabling or Disabling SNMP v1/v2c
This command enables or disables the SNMP v1/v2c protocol.
config:# network services snmp v1/v2c <option>
Variables:
<option> is one of the options: enable or disable.
Option Description
enable The SNMP v1/v2c protocol is enabled.
disable The SNMP v1/v2c protocol is disabled.
Description
Enables the password-based login only.
Enables the public key-based login only.
Enables both the password- and public key-
based login. This is the default.
PRO3X User Guide – Command Line Interface (CLI)
74 of 182
Using the PRO3X Command Line Interface (CLI)