LEGRAND Server Technology PRO3X User Manual page 51

Variables:
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must choose/configure the bridge
interface if your PRO3X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters of ETH1/ETH2
and WIRELESS interfaces do NOT function.
Interface Description
Determine the IPv6 preferred host name of the ETH1
eth1
interface (wired networking).
eth2 Determine the IPv6 preferred host name of the ETH2
interface (wired networking).
wireless Determine the IPv6 preferred host name of the
WIRELESS interface (that is, wireless networking).
bridge Determine the IPv6 preferred host name of the
BRIDGE interface (that is, bridging mode).
<name> is a host name which:
▪
Consists of alphanumeric characters and/or hyphens
▪
Cannot begin or end with a hyphen
▪
Cannot contain more than 63 characters
Cannot contain punctuation marks, spaces, and other symbols
Setting the IPv6 Address
After selecting the static IP configuration mode, you can use this command to assign a permanent IP address to the PRO3X.
config:# network ipv6 interface <ETH> address <ip
address>
PRO3X User Guide – Command Line Interface (CLI)
51 of 182
Using the PRO3X Command Line Interface (CLI)