LEGRAND Server Technology PRO3X User Manual page 13

IP Configuration
This command shows the IP settings shared by all network interfaces, such as DNS and routes. Information shown
will include both IPv4 and IPv6 configuration.
# show network ip common
To show the IP settings of a specific network interface, use the following command.
# show network ip interface <ETH>
Variables:
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must choose/configure the bridge
interface if your PRO3X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters of ETH1/ETH2
and WIRELESS interfaces do NOT function.
Interface Description
eth1 Show the IP-related configuration of the ETH1
interface.
eth2 Show the IP-related configuration of the ETH2
interface.
Show the IP-related configuration of the WIRELESS
wireless
interface.
bridge Show the IP-related configuration of the BRIDGE
interface.
all Show the IP-related configuration of all interfaces.
Tip: You can also type the command without adding
this option "all" to get the same data. That is, show
network ip interface.
PRO3X User Guide – Command Line Interface (CLI)
13 of 182
Using the PRO3X Command Line Interface (CLI)