LEGRAND Server Technology PRO3X User Manual page 143

Command line interface (cli)
Hide thumbs Also See for Server Technology PRO3X:
Table of Contents

Advertisement

Variables:
<n> is the number of the inlet whose pole sensors you want to configure. For a single-inlet PDU, <n> is always 1.
<p> is the label of the inlet pole that you want to configure.
Pole
Label
<p>
1
L1
2
L2
3
L3
<sensor type> is one of the following sensor types:
Sensor type
current
voltage
activePower
apparentPower
powerFactor
activeEnergy
unbalancedCurrent
Note: If the requested sensor type is not supported, the "Sensor is not available" message is displayed.
<option> is one of the options: enable, disable or a numeric value.
Option
Description
enable
Enables the specified threshold for the specified inlet
pole sensor.
Disables the specified threshold for the specified inlet
disable
pole sensor.
A numeric value
Sets a value for the specified threshold of the
specified inlet pole sensor and enables this threshold
at the same time.
Current sensor
Voltage sensor
L1
L1 - L2
L2
L2 - L3
L3
L3 - L1
Description
Current sensor
Voltage sensor
Active power sensor
Apparent power sensor
Power factor sensor
Active energy sensor
Unbalanced load sensor
PRO3X User Guide – Command Line Interface (CLI)
143 of 182
Using the PRO3X Command Line Interface (CLI)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Server Technology PRO3X and is the answer not in the manual?

Table of Contents