LEGRAND Server Technology PRO3X User Manual page 52

Variables:
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must choose/configure the bridge
interface if your PRO3X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters of ETH1/ETH2
and WIRELESS interfaces do NOT function.
Interface Description
Determine the IPv6 address of the ETH1 interface
eth1
(wired networking).
eth2 Determine the IPv6 address of the ETH2 interface
(wired networking).
wireless Determine the IPv6 address of the WIRELESS interface
(that is, wireless networking).
bridge Determine the IPv6 address of the BRIDGE interface
(that is, the bridging mode).
<ip address> is the IP address being assigned to your PRO3X. This value uses the IPv6 address format. Note that you must add
/xx, which indicates a prefix length of bits such as /64, to the end of this IPv6 address.
Setting the IPv6 Gateway
After selecting the static IP configuration mode, you can use this command to specify the gateway.
config:# network ipv6 gateway <ip address>
Variables:
<ip address> is the IP address of the gateway. This value uses the IPv6 address format.
PRO3X User Guide – Command Line Interface (CLI)
52 of 182
Using the PRO3X Command Line Interface (CLI)