Ipv4-Only Or Ipv6-Only Configuration - LEGRAND Server Technology PRO3X User Manual

IPv4-Only or IPv6-Only Configuration

To show IPv4-only or IPv6-only configuration, use any of the following commands.
To show IPv4 settings shared by all network interfaces, such as DNS and routes:
# show network ipv4 common
To show IPv6 settings shared by all network interfaces, such as DNS and routes:
# show network ipv6 common
To show the IPv4 configuration of a specific network interface:
# show network ipv4 interface <ETH>
To show the IPv6 configuration of a specific network interface:
# show network ipv6 interface <ETH>
Variables:
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must choose/configure the bridge
interface if your PRO3X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters of ETH1/ETH2
and WIRELESS interfaces do NOT function.
Interface Description
eth1 Show the IPv4 or IPv6 configuration of the ETH1
interface.
eth2 Show the IPv4 or IPv6 configuration of the ETH2
interface.
wireless Show the IPv4 or IPv6 configuration of the WIRELESS
interface.
bridge Show the IPv4 or IPv6 configuration of the BRIDGE
interface.
PRO3X User Guide – Command Line Interface (CLI)
14 of 182
Using the PRO3X Command Line Interface (CLI)