Network Interface Settings - LEGRAND Server Technology PRO3X User Manual

Interface Description
all Show the IPv4 or IPv6 configuration of all interfaces.
Tip: You can also type the command without adding
this option "all" to get the same data. That is, show
network ipv4 interface.

Network Interface Settings

This command shows the specified network interface's information which is NOT related to IP configuration. For example, the
Ethernet port's LAN interface speed and duplex mode, or the wireless interface's SSID parameter and authentication
protocol.
# show network interface <ETH>
Variables:
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must choose/configure the bridge
interface if your PRO3X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters of ETH1/ETH2
and WIRELESS interfaces do NOT function.
Interface Description
eth1 Show the ETH1 interface's non-IP settings.
eth2 Show the ETH2 interface's non-IP settings.
wireless Show the WIRELESS interface's non-IP settings.
bridge Show the BRIDGE interface's non-IP settings.
all Show the non-IP settings of all interfaces.
Tip: You can also type the command without adding
this option "all" to get the same data. That is, show
network interface.
PRO3X User Guide – Command Line Interface (CLI)
15 of 182
Using the PRO3X Command Line Interface (CLI)